When typing in a date in the UltraDateTimeEditor the value changed event is firing as soon as you type in the first digit of the year. This causes the date to be set in the control. I tested against Net Advantage 2009.1 and also the Service Release 2039.
To test create a winform drag a date time editor onto the form subscribe to the value changed event and put a break point on the event. Run app and type in a date. As soon as you type the first digit for the year part the event fires and sets the date.
This is only a problem if you subscribe to the value changed event.
Hi,
I am getting same problem what you had discussed earlier, I have assigned the value to the BO property through databindings, so I cannot add AfterExitEditMode for this control alone.
I am using custom control which is inherit from UltraDateTimeEditor(ver 9.1) , Is there anyway to solve this problem only change in the custom control?
Use the AfterExitEditMode event.
Then you can grab the date
mydate = dteTransferDate.DateTime.Date
I am quite new to Infragistics. I am using 8.2. I am also getting the same issue as stated above. When I am trying to update a date say from 12/11/2009 to 12/10/2009, as soon as I delete a one I am getting the date value as 12/01/2009. I have to again change the value to 12/10/2009. The problem can be clearly viewed when a breakpoing is used.
Can you tell me a work around for that??
Thanks.
You should probably contact Infragistics Developer Support for the details, but my understanding is that Developer Support was unable to determine any change in behavior from one version to the next. So if that's the case, the current behavior is, and always has been, the expected behavior.
Actually I don't want to report a problem here. I just want to know what is the indended behaviour, since the digitaldan3 says that behaviour change in the latest version. I'm using 9.1.20091.2012 and I see that ValueChanged event of UltraDateTimeEditor is fired when the user starts typing. digitaldan3 says that in previous version the event was fired when the control was losing focus (AfterExitEditMode).
I just want to know what is the expected behaviour regarding ValueChanged event so that I know how to use it.