UltraToolBarManager: Back and Fordward buttons (need help)

200

Daniel posted over 14 years ago

Please look at the following image:

How can I add or remove these buttons from the Toolbar as shown in the picture above?

I have seen some examples that use these buttons, but these examples do not clearly explain how to use it. I think those buttons are added in design mode... but I see no where.

I would like to know how to add or remove these buttons from the ToolBar.
I would like to know how to access to its properties, especially enabling or disabling these buttons.
I like to know about event handlers I have to use to capture the most common events (click for example) on both buttons (back and fordward).

Thanks in advance, any help will be greatly appreciated.

685

Prasant posted over 14 years ago in reply to Prasant

Hi All ...finally ..i got my answers here

http://blogs.infragistics.com/forums/p/25866/95350.aspx#95350 please try..this

Office2007UICompatibility = False

Ribbon.ApplicationMenu.Visible = False

Ribbon.QuickAccessToolbar.Visible = False
Cancel
Reply

Cancel
685

Prasant posted over 14 years ago in reply to Daniel

Hi All,Even i am having the same question..i wanted remove below highlighted area ..from my form..so please repond if any one ...resolved it earlier

thanks
Cancel
Reply

Cancel
200

Daniel posted over 14 years ago

OK,

Apparently, nobody on this forum can explain the use of this component.

This thread has spent several days here and nobody has been able to answer it.

Sincerely, it's a shame. I've had to remove this component of my application, after spending days trying to configure it properly and this is because there is no information on this and support is zero.

My company is looking to use other components with better support.

Thanks for nothing.
Cancel
Reply

Cancel