Hello,
when I run the Toolbox Utility for Version2011.1 on VS 2008 Professional SP1 it claims that it adds all components to the NetAdvantage tab. But in the last steps it will remove the tab from the toolbox. See output below.
Any suggestions besides choosing the toolbox items by hand?
Regards,
Torsten
Hi Torsten,
I have determined that there is in fact a log file generated for the Toolbox utility installation; by default it should be located within the documents folder …\Documents\Infragistics\Tools\Toolbox Utility\Toolbox Utility.log
The contents of this file may further illuminate the source of this issue. If you are able to attach it to this forum thread, I would be more than happy to review it for a possible cause.
If you have any questions at all, regarding this issue, please let me know.
Sincerely,Chris KDeveloper Support EngineerInfragistics, Inc.www.infragistics.com/support
Hi Chris,
I have indeed an older version 2009.2 installed. In the past it was no problem to have two versions installed parallel. During installation of the product, the Toolbox tab was not installed. Therefore I tried to set it up manually with the Toolbox utility. Are there any logfiles written during installation to see why it is failing?
The only situation I can think of that ‘might’ potentially cause this issue, is where there are more than one version of NetAdvantage installed on the same machine. The Windows Form product, however has a feature which, (normally) automatically installs the tab and toolbox component, when the product is installed; is there any particular reason why you are using the Toolbox utility, as this may shed some light on why the utility is failing.
Sincerely,
Chris K
Developer Support Engineer
Infragistics, Inc.
www.infragistics.com/support